IOVU-07F-AD RISC-based Panel PC
Page 22
than the overall size of the frame that surrounds the IOVU-07F-AD but just large
enough for the rear panel of the IOVU-07F-AD to fit through.
Step 3:
Slide the IOVU-07F-AD through the hole until the frame is flush against the
panel.
Step 4:
Insert the panel mounting clamps into the pre-formed holes along the edges of
the chassis, behind the frame. There are a total of four panel mounting clamps
for the IOVU-07F-AD.
Figure 3-7: Panel Mounting Clamps
Step 5:
Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel.
3.4.3 Arm Mounting
The IOVU-07F-AD is VESA (Video Electronics Standards Association) compliant and can
be mounted on an arm with a 75 mm interface pad. To mount the IOVU-07F-AD on an arm,
please follow the steps below.
Step 1:
The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
Содержание IOVU-07F-AD
