IEI Technology IDS-310-AL, Руководство пользователя

Страница: 83 / 114

IDS-310-AL Embedded System
Page 69

Wi-Fi module (see Section 3.4)
5.2.1 SO-DIMM Replacement
WARNING:
Using incorrectly specified SO-DIMM may cause permanently damage
the IDS-310-AL. Please make sure the purchased SO-DIMM complies
with the memory specifications of the IDS-310-AL.
To replace a SO-DIMM memory module into a SO-DIMM socket, please follow the steps
below.
Step 1: Remove the bottom surface. See Section 3.3 .
Step 2: Locate the SO-DIMM inside the bottom panel ( Figure 5-1 ).
Figure 5-1: SO-DIMM Location
Step 3: Remove the SO-DIMM by releasing the arms on the SO-DIMM socket. Align the
new SO-DIMM with the socket. The SO-DIMM must be oriented in such a way
that the notch in the middle of the SO-DIMM must be aligned with the plastic
bridge in the socket (
Figure 5-2
).
Step 4: Insert the SO-DIMM. Push the SO-DIMM chip into the socket at an angle
( Figure 5-2 ).