Page 34
Handheld Barcode Reader
4.1.5 Read Timing Setting
The user can configure the decode timeout, re-read delay and trigger interval settings by following
below procedures.
4.1.5.1 Decode Timeout Setting
Scan below barcode to start setting the maximum decode time while decoding. Then, scan a numeric
barcode from
Section 4.3
(Numeric Barcodes) to set the timeout duration (range: 80 ~ 4000), and
scan the
Save
barcode to apply the setting.
(Decode Timeout)
4.1.5.2 An Example of Setting the Decode Timeout
Below is an example of how to set the decode timeout to 600.
Scan
Decode Timeout
Scan 6
Scan 0
Scan 0
Scan
Save
Scan
Re-read Delay
(300 ~ 3000)
Scan
Trigger Interval
(1 ~ 5000)
Scan
Decode Timeout
(80 ~ 4000)
Scan 0 ~ 9
Save/
Discard
Scan Discard
Scan Save
Содержание HTDB-100F
