IEI Technology HTDB-100F, Руководство пользователя

Страница: 22 / 88

Page 12
Handheld Barcode Reader
Step 2: Connect the USB Standard Type A connector of the cable to the USB Type A
receptacle of a computer.
Once the HTDB-100F/100FM is connected to the computer, a beep should be
generated after about four seconds and the power LED ( Figure 1-1 ) turns on
(yellow), indicating that the barcode reader is fed with power.
NOTE:
The HTDB-100F/100FM will enter the backup mode if the user keeps
pressing the trigger button and connects the HTDB-100F/100FM to the
computer. To exit the backup mode, please reconnect the RJ-45 to
USB cable.
When the HTDB-100F/100FM cannot function normally or be
connected to the IEI HTDB UTILITY, the user can use the backup
mode to connect the HTDB-100F/100FM to the utility and update the
device firmware. Then, the barcode reader can be operated normally.
For firmware update procedures, please refer to Section 3.6 .
Step 3: Open a text editor, such as Notepad or Word, then present a barcode to the
HTDB-100F/100FM and press the trigger button. The HTDB-100F/100FM
projects a green scan line. Please aim the green scan line to the barcode within
the reading distance (refer to Table 2-2 for the reading distance of each barcode
type).
When a barcode is decoded successfully, the HTDB-100F/100FM generates a
beep and the decode LED ( Figure 1-1 ) flashes once. The decoded barcode
data is also displayed in the text editor.
In addition, the behavior of the buzzer and decode LED for a successful decode
can be changed. Please refer to Section 4.1.2 to set up the indicator mode.
Step 0: