IEI Technology ECW-281B-D525, Руководство пользователя

Страница: 51 / 107

ECW-281B/B2-D525 Embedded System
Page 39
4.2.5 Hard Drive Installation
One 2.5” SATA hard drive supported. The SATA drive is installed into a hard drive bracket
attached on the inside of the bottom panel (
764
Figure 4-7
).
Figure 4-7: Hard Drive Bracket
To install the hard drive into the system, please follow the steps below.
Step 1:
Remove the bottom surface See Section
764
4.2.3.
Step 2:
Remove the hard drive bracket from the bottom surface by removing the four
retention screws that secure the bracket to the bottom surface. (
764
Figure 4-8
)
Figure 4-8:HDD Bracket Retention Screws
Step 3:
Place the HDD into the bracket.