IEI Technology ECA-200, Быстрое руководство по установке

Страница: 7 / 11

6
HARD DISK DRIVE INSTALLATION
Step 1: Attach the HDD to the HDD bracket.
To do this, slide the HDD to the HDD
bracket and secure the HDD to the HDD bracket with four retention screws.
Step 2: Install the HDD bracket to the chassis. Install the bracket with HDD to the
chassis by aligning the bracket retention screw holes in the top of the HDD bracket
with the retention screw holes on the chassis. Secure the HDD bracket to the chassis
with the screws as figure shown below.
-----------------------------------------------------------------------------------------------------------------
NOTE:
The SATA cables from the installed HDD must be connected to the SATA connector
and SATA power connector on the motherboard before installing the top panel to the
chassis. To correctly connect these cables, please refer to the user manual that came
with the motherboard.
-----------------------------------------------------------------------------------------------------------------
FRONT PANEL CABLE CONNECTION
The following buttons and LEDs are on the front panel of the ECA-200 chassis.

1 x Power switch

1 x Reset button

1 x HDD LED

1 x Power LED
These components are all connected to the motherboard with cables. To correctly
connect these cables, please refer to the user manual that came with the
motherboard.