IEI Technology AFL3-W07A-BT-N1, Руководство пользователя

Страница: 37 / 109

AFL3-W07A-BT-N1 Panel PC
Page 25
3.7.2 Panel Mounting
To mount the AFL3-W07A-BT-N1 flat bezel panel PC into a panel, please follow the steps
below.
Step 1: Select the position on the panel to mount the flat bezel panel PC.
Step 2: Cut out a section corresponding to the size shown below. The size must be
smaller then the outer edge.
Figure 3-12: Cutout Dimensions
Step 3: Slide the flat bezel panel PC through the hole until the frame is flush against the
panel.
Step 4: Align the panel mounting bracket screw holes with the VESA mounting holes on
the rear of the panel PC.
Step 5: Secure the two panel mounting brackets to the rear of the panel PC by inserting
the four retention screws into the VESA mounting holes ( Figure 3-13

).
Step 6: Insert the panel mounting clamps into the pre-formed holes along the two edges
of the panel mounting brackets ( Figure 3-13

). There are a total of 4 panel
mounting clamps for AFL3-W07A-BT-N1.
Step 7: Tighten the screws that pass through the panel mounting clamps until the plastic
caps at the front of all the screws are firmly secured to the panel
( Figure 3-13

). S te p 0 :