AFL3-W15B-H81 Panel PC
Page 38
Step 7:
Once the flat bezel panel PC with the attached rack/cabinet bracket has been
properly inserted into the rack or cabinet, secure the front of the rack/cabinet
bracket to the front of the rack or cabinet (
Figure 3-22
).
3.12.4 Arm Mounting
The AFL3-W15B-H81 is VESA (Video Electronics Standards Association) compliant and
can be mounted on an arm with a 75 mm or a 100 mm interface pad. To mount the
AFL3-W15B-H81 on an arm, please follow the steps below.
Step 1:
The arm is a separately purchased item. Please correctly mount the arm onto
the surface it uses as a base. To do this, refer to the installation documentation
that came with the mounting arm.
NOTE:
When purchasing the arm please ensure that it is VESA compliant and that
the arm has a 75 mm a 100 mm interface pad. If the mounting arm is not
VESA compliant it cannot be used to support the AFL3-W15B-H81 flat
bezel panel PC.
Step 2:
Once the mounting arm has been firmly attached to the surface, lift the flat bezel
panel PC onto the interface pad of the mounting arm.
Step 3:
Align the retention screw holes on the mounting arm interface with those in the
flat bezel panel PC (
Figure 3-23
).
