IEI Technology AFL2-W19A-H61 Series, Руководство пользователя

Страница: 133 / 279

AFL2-W19A/AB-H61
P a g e 113
6.3 J u m p e r S e ttin g s
NOTE:
A jumper is a metal bridge used to close
an electrical circuit. It consists of two or
three metal pins and a small metal clip
(often protected by a plastic cover) that
slides over the pins to connect them. To
CLOSE/SHORT a jumper means
connecting the pins of the jumper with
the plastic clip and to OPEN a jumper means removing the plastic clip
from a jumper.
The following jumpers can be found on the motherboard installed in the
AFL2-W19A/AB-H61. Before the AFL2-W19A/AB-H61 is installed, the jumpers must be
set in accordance with the desired configuration. The jumpers on the AFL2-W19A/AB-H61
motherboard are listed in Table 6-31 .
Description Label Type
LVDS voltage selection DJ2 3-pin header
LCD panel selection DJ3, DJ4, DJ5, DJ6 2-pin header
Table 6-31: Jumpers
6.3.1 LVDS Vo lta g e S e le c tio n
J u m p e r La b e l: DJ2
J u m p e r Typ e :
3-pin header
J u m p e r S e ttin g s : See Table 6-32
J u m p e r Lo c a tio n : See Figure 6-35
Use the LVDS voltage selection jumper to select the voltage of the LVDS connector.