Cabinet Heater G*Y/D*Y Series
INSTALLATION, OPERATION, & MAINTENANCE MANUAL
11
SECTION ONE — Installation, Cont'd.
Optional Trim Kit Installation
An optional trim kit can be applied to partially recess the
GXY, GSY units in the wall. The trim kit can also be applied
to cover rough opening to eliminate the need for finish
work such as carpentry, drywall, painting, etc.
Reference unit submittal drawings for unit sizes. Trim kits
have 1" flanges.
There are 3 mounting brackets (two sides, one top)
provided in the trim kit for floor mount units. There are
4 mounting brackets (two sides, top, bottom) in the trim
kit for wall mount units. There are no mounting holes
provided on the unit so the brackets can be positioned at
whatever depths is required for recess. Use self tapping
screws to secure the brackets to the unit.
Figure 11. Trim Kit Around Floor Mount Unit
Horizontal Series Unit Installation
DBY, DXY
Anchoring the equipment in place is accomplished by
using the mounting points provided with 3/8” all-thread
rod and other hardware (not supplied with unit). The
unit must be positioned so that the coil or electric heat
elements are on a LEVEL PLANE.
Other field-furnished mounting devices such as rubber-
in-shear or spring-type vibration isolators selected by the
contractor or engineer may be substituted for the factory
grommets and should be used where factory grommets
are not provided. Refer to the device manufacturer for
installation instructions.
It should be noted that unacceptable system operating
characteristics and/or performance may result from
improper or inadequate unit structural support. Adequate
clearance must be provided for service and removal of the
equipment and any accessory components.
Table 5. Threaded Rod Recommendations
Model
Rod Diameter Rod Qty
D*Y 02, 03, 04, 06, 08,10,12
3/8”
4
*NOTE – Threaded rods and hardware are provided by others.
Figure 12. Channel Mount Suspension*
*NOTE – Figure 12 depicts DBY. Hanger rails and hardware are provided by others.
Cabinet unit models DBY and DXY may be mounted using
four neoprene grommets provided in the four hanger holes
in the case top.
