Subject to change without prior notice
Version 01
Copyright © 2022 iDTRONIC GmbH
2022-04-11 / MB
ID IDENT 4000 User Manual EN v01.docx
Page 18 of 18
8. Attention
1. The equipment standard is 12-24V power supply, it can get power from the access control power
or power it separately. Excessive voltage may cause the device to fail to work normally or even
damage the device.
2. Do not disassemble the scanner without permission, otherwise the device may be damaged.
3. For Ethernet scanner, it is necessary to ensure a good network environment, otherwise it may be
unable to communicate with the server.
4. The installation position of the scanner should avoid direct sunlight. Otherwise, the scanning effect
may be affected. The panel of the scanner must be clean, otherwise it may affect the normal image
capture of the scanner. The metal around the scanner may interfere with the RFID magnetic field and
affect card reading.
5. The wiring of the scanner must be firm. In addition, ensure the insulation between the lines to
prevent the equipment from being damaged by a short circuit.
6. The output of the scanner is a switch signal. In an access control scenario, it can be connected to
the original access control system according to the normally open or normally closed connection
method of the original access control system.
9. Contact info
iDTRONIC GmbH
Ludwig-Reichling-Straße 4
67059 Ludwigshafen
Germany
Phone: +49 621 6690094-0
Fax: +49 621 6690094-9
