You will need
As you unpack and begin to set up your new electrisave ™ you will need the following equipment:
• User manual – for instructions on how to set up and use the product.
• A hammer and 2x 2mm head nails – to fix the mounting bracket/unit to the wall. Alternatively you may screw the bracket to
the wall or simply place the transmitter carefully inside the meterbox.
• A small Philip’s-head screw driver - to open the battery compartment of the Transmitter.
Unpacking the product
When you unpack your electrisave™, make sure to keep all the packing materials in a safe place, in case you need to later
transport or return it for servicing.
In the box, you will find:
Batteries
The Portable Main Unit Receiver and the Remote Transmitter both use 3 x UM-3/AA 1.5V alkaline batteries. No other power
source is necessary to run the units.
Loading the batteries:
Main unit – Receiver
NOTE
Replace the batteries whenever the weak battery mark ‘main’ or ‘remote’ () shows, the display is dim, or the display
does not illuminate when the power is on. Replace all the batteries at the same time – it is
unwise
to mix old and new
batteries.
Contact your local waste disposal authority for instructions on how to dispose of used batteries. Used batteries can be
harmful to the environment, and should not be thrown out with household rubbish.
AC Adaptor
The main unit receiver can operate with a 6.0V AC/DC adaptor, which can be purchased separately.
9
GETTING STARTED
Main Unit
Receiver
Diagram
Instructions
Diagram
Instructions
Remote Transmitter
(with wall Bracket)
Current Sensor
Batteries x 6
AA alkaline
User Manual &
Quick Install Guide
Install the batteries by matching the
correct polarity. Always use the
correct battery type (
3 x UM-3/AA
1.5V alkaline batteries
).
Warning:
Reversing the polarity
may damage the product.
Remove the cover with a
screwdriver. Then follow the same
instructions as the main unit.
Once done, replace the cover and
screw back the cover onto the unit.