700-604-02A Xwave Repeater Manual
+
+
+
Adding Batteries
The 3 x AA rechargeable batteries need to be installed into the unit first.
1.
Rotate the stand to access the screw. (Figure B & C above)
2.
Remove the housing screw with a flat screw driver.
3.
Open the housing by pulling the bottom of the white housing away from the black
housing as there are clips at the top hold the housing together. (Figure C above)
4.
Place the 3 AA batteries into the battery holder as indicated on the battery holder
and figure 2.
5.
Once the batteries are inserted clip the white front housing into top clips and bring
the bottom of the front and back housing together and insert screw.
Figure 2: Batteries
Learning detectors into a channel
Six Xwave detectors can be learnt into any of the six channels. (One detector per channel.)
Note:
Please see detector manuals for information on tampering.
1.
Make sure the system is in idle mode by making sure none of the visual modes are
selected. (See visual Indicators sections.)
2.
Press the channel button for 3 seconds, until a beep is heard, and the button begins
to flash.
3.
Tamper the detector to be paired with this channel.
4.
Button will stop flashing and illuminate for 5 seconds as a 1 second beep is heard to
indicate detector has been learnt.
5.
Programming will be exited.
6.
Follow steps 1 to 5 for each channel being learnt.
Note:
Programming will automatically be exited after 60 seconds of no activity or if the
channel button is pressed for 3 seconds without a detector being tampered.
Delete a channel
1.
Make sure the system is in idle mode by making sure none of the visual modes are
selected. (See visual Indicators sections.)
2.
To confirm a detector has been learnt into the channel, press and release the
channel button and the channel LED will illuminate for 5 seconds.
3.
Press channel button for 10 seconds, wait for the triple beep indicating that the
channel is now detector free.
4.
Delete mode is automatically exited when detector is deleted.
