IDS MKII, Руководство по установке

Страница: 12 / 16

IDS Digital Remote Receiver MKII 700-373-02C Issued April 2010 12
Clear other switches to return to standby mode.
The ARMED LED is on.
6.6 Relay Parameter Selection and Setting
Parameter Reset (Defaults all the parameters - remote buttons are NOT erased)
Set DIP switch 1, 5, 6, and 7.
Set DIP switch 8.
Clear DIP switch 8, the receiver returns to standby mode.
6.7 Relay Pulse Period
Default 3 seconds for both relays.
Set DIP switch 7, then 8
The ARMED LED flashes very fast.
Select DIP switch 1 (for relay 1) or 2 (for relay 2) or both 1 and 2 for relays 1 and 2.
Wait for the time you would like the relay to pulse
Clear DIP switch 8 to commit timed period to memory
The ARMED and READY LED’s will flash.
Clear other switches to return to standby mode.
7. Fault Finding
7.1 Amber LED Indicator
The sole function of this LED is to indicate when there is a valid bus connection between the receiver and
an IDS Alarm Panel.
7.2 Red and Green LED Indicators
LED behaviour in STANDBY MODE
When the receiver decodes a valid (but unlearned IDS remote), the red LED will temporarily turn off. If it
decodes a learned remote, the green LED will turn on for the period that the receiver signal is present.
Upon decoding the learned remote, the respective relay is triggered and an appropriate message is sent
to the Alarm Panel.
LED behaviour in PROGRAMMING MODE
During the programming process, the green and red LEDs indicate the current programming function
with combinations of FOUR different indications:
Status Action
OFF the LED is OFF
ON the LED is shining continuously
Slow the LED is blinking slowly (one pulse per second)
Fast the LED is blinking fast (five pulses per second)