53
⑥
To set print area. Please set it properly to print on an entire card because SMART-50 is a
direct thermal card printer. When you click “
⑦
Print”, a card is printed as like “
④
example”.
Please set values properly that all circles of each corner are printed and blank spaces are
0.4mm ~ 0.5mm in the top and the bottom of a card. Please set values by following order.
X Start Position:
Please set right and left properly by adjusting X position.
Y Start Position:
Please set the start position of printed example image and blank space in
the top is 0.4mm ~ 0.5mm.
Y End Position:
Please set the end position of printed example image and blank space in
the bottom is 0.4mm ~ 0.5mm. It is recommended to set bigger value for “Y scale” than
default.
Y Scale:
Please set to show circles in the bottom.
⑦
To set density. SMART-50 enables to set different density for each color, resin black and
overlay. So, please set each density for high quality. Please optimize the quality by
adjusting each value. To optimize, you repeatedly adjust the density and print a Calibration
card and check the print state until you get the optimum.
If your printer is SMART-50 RW model, please do not install ribbon. You can set
density with Rewritable cards. Please adjust total density only.
Total Density:
To set all of the density (Color, Black and Overlay) at one time.
If your printer is SMART-50 RW model, when the density is too strong, you will have
darker background color. (Background color may vary depending on card type.)
When density is proper, texts and images are printed clearly and there is no
background color. When density is too low, texts and images are printed dull.
Pic.106 SMART-50 RW density
YMC Density:
To set color density. Please maximize YMC density as you can, which
enables to express range of color and vivid images. If it is too strong, green or red marks
are appeared. If it is too weak, the print quality will be dull. (Please refer Pic.105.)
