(C) IDM Energiesysteme GmbH
Installation instructions AERO ILM
39
Example of outlet side on the right
Installation
5.12.3. Assembly instructions - fl exible air hose - air outlet sideways
Air inlet side
Procedure as in corner installation
Outlet panel:
The outlet panel is mounted to the desired side using
the 4 screws included in the delivery contents.
A trapeze-shaped insulation with adhesive tape on
both sides is included with the outlet panel. This has
to be a
ffi
xed to the panel on the evaporator side.
Wall
fl
ange:
The wall
fl
ange has to be mounted to the air outlet
opening using suitable assembly material. Four bore
holes in the corners of the
fl
ange are provided for that
purpose!
Flexible hose:
The hose can be cut to length as desired! In connect-
ing the hose with the two
fl
anges the hose insulation
is telescoped at the two ends.
The hose is mounted to the
fl
ange using a hose
clamp. This enables the insulation to be extended
over the
fl
ange again!
The air hose is
fl
exible and enables an outlet in all
directions. The minimum bending radius is 600 mm!!
The air hose should be straight as far as
possible and should not make any un-
necessary changes in direction . The air
hose should be suspended every 0.5 m
with an assembly tape (perforated tape)!
The heat pump must only be moved us-
ing the mounted panels!
