Part 2 - Configuration
40
Video Loss
•
Video Loss Interval:
The system does not produce
event log entries or issues remote notifications
regarding video loss detected during the specified
time following the initial video loss detection. Set a
value between 0.1 sec and 15 secs or choose Never.
•
Actions
: Specify which actions to take when a Video
Loss event occurs.
–
Record
: Specify which cameras to begin linked
recording on when an event occurs. If the schedule
is set to
Event
or
Time & Event
mode, the selected
cameras will begin linked recording when an event
occurs.
–
Alarm-Out
: Designate event-triggered alarm-out
channels and beeps.
–
Notify
: Configure to be notified of events by
Mail, LAN1 through 5, SNS, FTP, Push, and/or Alert
Window.
–
PTZ
: Moves the PTZ camera to a specific preset
position when an event occurs.
In order to use the Callback(LAN 1~5) feature, the DVR
must be registered on the remote program.
•
Use Ignoring Time
: Select
Time Setup
to specify the
video loss detection ignore time. Video loss detection
will be disabled during the specified time frame.
Video Blind
•
Sensitivity
: Allow you to adjust the DVR’s sensitivity
to video blind for Black and White independently from
0 (Never) and 1 (least sensitive) to 15 (most sensitive).
Video blind might NOT be detected for a camera
with a very noisy image especially when set for low
sensitivity values.
•
Activation Time:
Allow you to set the duration before
the DVR will report a Video Blind. The DVR will not
consider any blinded camera to be a Video Blind if the
detected blindness is less than the Activation Time set
on this screen.
