Part 2 - Configuration
38
Advanced Setup
Configure security and other advanced camera settings.
●
Video: Adjust the camera image sensor settings such
as white balance and exposure.
●
Privacy Masking: Enable/disable and configure
privacy masking for the camera.
●
SSL: Set the camera’s security level as Unavailable,
Standard, High, or Very High. Standard, High and
Very High settings apply SSL (Secure Sockets Layer)
protection to the camera.
●
Reset: Resets the port or cameras.
– PoE Reset: Control the PoE Switch’s port. This
option is available when connecting to Video In/
PoE port or using a DirectIP™ PoE Switch (optional).
Select PoE Reset to reboot the camera. It is not
supported by video encoders.
– Soft Reset: Reboots the camera.
– Factory Reset: Resets the NVR to all its initial
factory settings. It is supported by DirectIP™
cameras only.
●
Mode: Select a resolution mode. This is supported by
video encoders only.
●
PTZ: If using an RS-485-compliant camera, configure
it for use in PTZ Mode.
– PTZ Product: Choose to select the model of
installed PTZ device.
– ID: Choose to assign an ID to each PTZ device.
– Choose to set up Baud Rate, Data Bit, Stop Bit
and Parity of the connected device.
Refer to the PTZ device manufacturer’s instructions
for the proper settings.
Types of configuration options shown vary
depending on the PTZ functions supported by the
camera.
1
2
3
4
5
6
7
8
9
0
Numbers shown below Preset, Scan, Pattern, and
Tour indicate the numbers of configured functions.
1
Preset
Use the buttons below to choose a preset position.
– Directional Buttons (
):
Used to tilt and pan the camera.
– Zoom (
): Zoom in and out.
– Focus (
): Adjust camera focus to far or near.
– Speed: Specify the camera’s panning and tilting
speed.
●
Set: Choose a preset number and then enter a name.
This saves the current preset under the specified
preset number and name.
●
Go to: Select a preset from the list and then click Go
to to move the camera to the selected preset position.
●
Edit: Used to change the selected preset’s name.
●
Remove: Used to remove the selected preset.
2
Scan
Used to set up a profile for moving the camera between
!
