Part 1 – Introduction
11
Flushed
Housing
1
2
1
2
1
2
1
2
1
Cable Grand
2
Mounting Clamp
•
Cable Grand
For routing cables and wires.
•
Mounting Clamp
Secures the camera to the ceiling.
Cable
1
2
4
3
5
1
Network Port
2
Power
3
Audio In/Out
4
Alarm Out
5
Alarm In
•
Network Port
Connect a network cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can configure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the
IDIS Discovery operation manual
.
•
Power
Connect the 24VAC power.
•
Audio In/Out
–
L_I
: Connect an audio source to this port. (line in)
–
L_O
: Connect an amplifier to this port (line out).
This device does not feature a built-in audio
amplifier unit and therefore requires the user to
purchase a separate speaker system with a built-in
amplifier.
•
Alarm In/Out
–
ALI
:Connect an alarm-in device to this port.
(Mechanism: Choose between an NC (Normally
Closed) type or an NO (Normally Open) type)
→
Connect a mechanical or electrical switch to the
alarm in port and the GND (ground) connector.
Alarm in range is 0V to 5V. In order to detect alarm
input from an electrical switch, the signal must be
higher than 4.3V from an NC switch or less than
0.3V from an NO switch and must last for longer
than 0.5 seconds.
