Part 1 – Introduction
10
I/O Connector
Alarm
In
Alarm In
GND
Grounding
Out
Alarm Out (Active Low -
Open Collector Output)
Audio
In
Audio In
GND
Grounding
Out
Audio Out
Factory Reset
Only use the factory reset button to restore the camera
to its factory default settings.
A factory reset will clear all camera settings configured
by the user.
1
Shut off the power supply.
2
Remove the dome cover and then press the reset
button down.
3
Hold the button down and reconnect the power
adapter.
4
Once the device turns back on, wait 5 seconds, and
then release the reset button.
5
The device will go through the resetting process and
reboot. All camera settings will be restored to their
factory defaults after the reboot.
It's also possible to do a factory reset by pressing and
releasing the reset button while the camera is turned
on or using the IDIS Discovery program from a remote
location. A factory reset will reboot the system. For more
information on factory reset, refer to the
IDIS Discovery
operation manual
.
Lens
Motorized focus and zoom lens
When installing or handling the camera, be careful not
to give an impact on the lens to prevent a malfunction
from occurring.
