Idis DC-D3533HRX, Руководство по установке

Страница: 10 / 26

Part 1 – Introduction
10
DC-D3533RX
5
6
3
4
1
7
2
8
#
$
%
0
9
!
@
1
Horizontal Rotator
2
IR LED
3
Vertical Rotator
4
Lens Rotator
5
Lens
6
Dome Cover Assembly Part
7
Bottom Cover
8
Power
9
Network Port
0
Cable Rubber
!
Wall/Ceiling Installation Hole
@
Video Out
#
Factory Reset Switch
$
SD Memory Card Slot
%
Alarm I/O, Audio I/O
^
Install Bracket Assembly Hole
&
NPT 3/4" Cover
•
Horizontal Rotator
Used to adjust the lens' horizontal angle.
• IR LED
A sensor in the middle monitors lighting levels and
activates the IR LED during low-lighting conditions.
•
Vertical Rotator
Used to adjust the lens' vertical angle.
•
Lens Rotator
Loosen the rotator screw, and turn the lens rotator
clockwise or counterclockwise to adjust the lens'
rotation angle by using the lens rotator handle. Then
tighten the rotator screw to lock it in place.
•
Lens
motorized focus and zoom lens is installed.
• Dome Cover Assembly Part
The dome cover rotates on the bottom cover and is
tightened.
•
Bottom Cover
Allows you to install the camera on a wall or a ceiling.
•
Power (DC12V)
Connect this to the power adapter. A A-type jack
is used for the power adapter. (External diameter x
internal diameter: 5.5 x 2.5)
•
Network Port
Connect a network cable with an RJ-45 connector to
this port. If using a PoE switch, you can supply power
to the camera using an ethernet cable. For more
information on PoE switch use, refer to the switch
manufacturer's operation manual. You can configure,
manage, and upgrade this camera and monitor its
images from a remote computer over the network.
For more information on network connection setup,
refer to the
IDIS Discovery operation manual
.