Part 1 – Introduction
9
Body
1
2
3
4
5
6
7
#
@
!
0
9
8
1
Lens
2
Lens Rotator
3
Horizontal Rotator
4
SD Memory Card Slot
5
Factory Reset Switch
6
Safety Wire Screw Hole
7
O-Ring Groove
8
Wall/Ceiling Installation Hole
9
Dome Cover Screw Hole
0
Bottom Cover
!
I/O Device Port
@
Cable Access Hole
#
Vertical Rotation Adjustment Screw
•
Lens
Varifocal auto-iris lens is installed.
•
Lens Rotator
Turn the lens rotator clockwise or counterclockwise
to adjust the lens' rotation angle.
•
Horizontal Rotator
Used to adjust the lens' horizontal angle.
•
SD Memory Card Slot
Used to insert a microSD memory card into
the camera. (An SLC (Single Level Cell) or MLC
(Multi Level Cell) card by SanDisk or Transcend is
recommended)
•
Do not remove the SD memory card while the
system is in operation. Removing the card while
the system is in operation can cause the system
to malfunction and/or corrupt data stored on
the SD memory card.
•
An SD memory card is a consumable product
with a finite service life. Prolonged use will
damage the card's memory sectors and result
in data loss or memory card failure. Test the SD
memory card regularly and replace it whenever
necessary.
•
Factory Reset Switch
Restores the camera's default factory settings. For
more information, refer to the
•
Safety Wire Screw Hole
Use the provided screw to secure the safety wire on
to the dome cover and the bottom cover.
•
O-Ring Groove
O-ring is seated in the groove for waterproof. Do NOT
remove the o-ring from the groove.
•
Wall/Ceiling Installation Hole
Used to screw the camera in place on a wall or a
ceiling.
•
Dome Cover Screw Hole
Secures the dome cover to the camera.
