iDirect iQ Desktop+, Инструкция по установке, поддержке и обслуживанию

Страница: 26 / 52

14 Installation, Support, and Maintenance Guide
iQ Satellite Router
Installation Steps at a Glance
• When selecting the site, consider accessibility, power availability, signal, network
connections, and the possibility of future expansion
• Carefully examine the work area for possible hazards, such as wet floor, ungrounded
power extension cables, and missing safety grounds
• Install the iQ Satellite Router in a location where access is unobstructed
• Ensure the iQ Satellite Router has adequate ventilation
• Do not install the iQ Satellite Router on the floor
• Select a suitable dust free location
• To protect the equipment and to avoid personal injury, observe the physical and
environmental considerations below when installing an iQ Satellite Router:
•
Power Cord Protection
Route power supply cords so they will not be walked on or pinched; pay particular
attention to cords at plugs, convenience receptacles, and at the exit points
• Overloading
Do not overload wall outlets, extension cords, or integral convenience receptacles
• Heat
Do not place the iQ Satellite Router near heat sources, such as radiators,
heat registers, stoves, or other products (including amplifiers) that produce heat
• Attachments
Do not use attachments unless recommended by the manufacturer
• Grounding
Never defeat the ground conductor or operate the equipment without a suitably
installed ground conductor. Contact the appropriate electrical inspection authority or
an electrician if it is uncertain that suitable grounding is available
4.1.2 Installation Checklist
1. Unpack the router according to the unpacking instructions in Section 4.3, Unpacking
iDirect Equipment on page 15 .
2. Account for all components for the installation. A typical list is given in Section 4.4,
Components Typically Included in an Order on page 16 .
3. The recommended tools should be available for installation. See Section 4.2, Tools and
Supplies Required for Installation on page 15 .
4. Prepare the coax cables as directed in Section B.1, Coax Cable Preparation on page 25 to
connect to RX IN and TX Out.
CAUTION: Do not connect or disconnect the Tx or Rx IFL cable while the
satellite router is powered on; this action may result in damage to the BUC,
LNB, and/or iQ Satellite Router.
ATTENTION: Ne pas connecter ou déconnecter les câbles « Tx IFL » ou « Rx
IFL » quand le routeur est sous tension, sous risque de dommage au BUC, au
LNB, et/ou au routeur iQ Satellite Router.