iDirect Evolution X1, Руководство по установке

Страница: 122 / 130

106 iDirect Satellite Router Installation and Commissioning Guide
iDX Release 3.3
Remote Installer Duties
After acquisition, record the baseline readings as outlined below. The data serves as a
reference in case the antenna is moved or some other service issue arises.
Baseline readings are checked periodically by the Network Operator to ensure that the service
is not degrading. Many events such as bad weather, sand or dust storms, solar flares,
movement of the antenna, or aging can cause the levels to change. For transient events,
monitor the levels to confirm return to the baseline values.
Follow the procedure in “Recording Remote Status Using a Console Connection” to record the
baseline readings for all model types except for Evolution X1, X7, and e150 Satellite Routers.
For those models, follow the procedure in
“Recording Remote Status Using Web iSite” on
page 107 on page 107 .
18.2.1 Recording Remote Status Using a Console Connection
Follow the steps in this section if commissioning an Evolution X3, X5, e8350, or e8xx Satellite
Router.
To Display Remote Status Messages:
1. Telnet to the Satellite Router or open a terminal session to the Satellite Router. See
“Connecting to the Console Port” on page 17 for details, including default passwords.
2. Log in as root and
telnet localhost
to the admin account.
3. At the prompt, enter the
rmtstat
command. The command toggles Status Message
printing On or OFF. Confirm that the return message is “
Printing Remote Status
messages is ON
”. See Figure 59 .
Figure 59. Remote Status Message
4. Wait for
Remote Status:
to display. The message updates periodically. Record the
following data from the remote status message:
a.
SNR
(Signal-to-Noise ratio of downstream carrier)
b.
TxPower
(IF output power in dBm)
c.
RxSignalPower
(Total composite input power seen by the receiver)
d.
Temp
(Operating temperature in degrees Celsius)
5. Report the readings to the Network Operator, and save locally for future reference