Installation & Operator Manual for MDS
L280-0960 Rev. C
7
6.1.
Mount Two Main Monitors.
Tools
: 5/32” Hex Key, Torqueing Phillips (Cross) Screwdriver, #222 Loctite and
Orange Torque Seal.
Procedure:
6.1.1.
Using a 5/32” Hex Key, remove the MDS Back Panel by removing all the
upper and lower Socket Head Cap Screws.
6.1.2.
Locate and confirm the upper and lower rail Locking Collars are secure and in
place against the top and bottom Counterweight Bracket Flanges as shown in
the photos below.
NOTE:
The upper and lower Locking Collars are used to secure the Arms for shipping only,
and after they are relocated the Vertical Travel Lock Hooks should ONLY be utilized during
transportation of the unit.
6.1.3.
Unpack the two main Monitors carefully and lay them face down on a
protective surface.
6.1.4.
Locate and remove the four mounting screws on the back panel of the Monitor.
WARNING!
If the Locking Collars are found to be loose, secure with the Hex
Key before proceeding.
