MICROPUMP, INC.
A Unit of IDEX Corporation
PO Box 8975, Vancouver, WA 98668-8975 • Phone: 360/253-2008 • Fax: 360/253-8294
MICROPUMP
LIMITED
A Subsidiary of Micropump, Inc.
2 Howard Road, Eaton Socon, St.
Neots, Cambridgeshire, PE 19 8ET England, • Phone: 011-44-1480-356600 • Fax: 011-44-
1480-
356300
Page 25 of 33
7.5 Assembly of Model 668-400-2. (Refer to Figure 1 in IPL.)
7.5.1 Install bracket (3) on Model 668-400-2.
7.5.2 Attach bracket (3) to Model 668-400-2 with clamp (2).
7.6. Storage
7.6.1 Preparation
7.6.1.1 Install plugs in outlet and inlet ports.
Note: Tape can be used in lieu of plugs to cap ports.
7.6.2 Storage Conditions
7.6.2.1 Store Model 668-400-2 in horizontal position in a normal ambient
temperature-humidity environment.
8. Special Tools
8.1 Only one special tool, a bushing insertion tool, is required to maintain the Model 668-
400-2 Pressurematic Water System. It is used to press new bushings into the pump
body assembly and base assembly. The bushing insertion tool is fully described in
Figure G. It is available from Micropump, Inc. as P/N 5465.
Bushing Insertion Tool
Figure G
