95
THE MODULE DEUTSCH CONNECTORS ARE KEYED; HOWEVER, ALL MODULES UTILIZE
THE SAME TWO KEYS. VERIFY THE HARNESS LABEL AND THE MODULE PART NUMBER
TO ENSURE THE CORRECT MODULE AND HARNESS CONNECTOR ARE BEING CON-
NECTED.
D.
Connect electrical connectors according to tags.
E.
Install cable ties cut to R&R module as noted.
4.8.2
Sensor Module
The sensor module (Figure 69) connects to the Green CAN buss, allowing the majority of the SAM
sensor outputs to be integrated on to the buss for processing of statuses and/or display of ap-
propriate alerts (see Figure 15, page 18). Discrete inputs/outputs are indicated by the direction
of the arrow symbol provided with each signal name (pin) and buss connections are indicated via
circles instead of arrows. See Figure 70.
Figure 69. Sensor Module
Figure 70. Sensor Module Interface Layout
NOTE
When the sensor module is replaced, the new module may NOT retain the revision
history and pump information. This previously stored information may be lost.
The sensor module installs on the Hale provided bracket located on the front of the pump di-
rectly above the circuit breaker box and Autolube assemblies (left most module on its own
bracket). Connect the module according to Table 50.
Содержание Hale Sam
