C00169 Hand Tool
Cleaning and
Accessories
Gripper Cleaning Instructions:
1. Remove gripper. Align gripper pin
hole with notch in tool frame. Using a
punch and hammer, punch pin out of
slide block.
2. Using a wire brush, clean all
foreign matter from teeth.
3. Replace pin. Gripper spring must be
seated in tension screw hole. Align
gripper hole with slide block hole, insert
pin in hole and hammer pin in place.
Scru-Lokt Buckles:
1. The BAND-IT Scru-Lokt clamp,
using the Scru-Lokt buckle, is
applied in exactly the same way as
the BAND-IT clamp except that the
tool is not rolled over.
2. After tension is applied, insert set screw in
Scru-Lokt buckle and tighten. To permit
taking up Scru-Lokt clamp, or to re-use, a 3
inch (7.5 cm) stub should be left so that tool
will be able to re-grip band later.
3. Where stub of band is left
for Scru-Lokt clamp, it may be
folded under as shown.
Tool Accessories:
JR Adapters: The JR adapters (J00169 and J05069 heavy duty) are used with the BAND-IT C00169 tool when
BAND-IT JR. preformed clamps are used.
C04388 Close Quarter Tension Nut: In cramped quarters, use instead of tool tension handle.
NOTE: See general catalog or web site for instructions and ordering information.
CABLE JOINTS, CABLE TERMINATIONS, CABLE GLANDS, CABLE CLEATS
FEEDER PILLARS, FUSE LINKS, ARC FLASH, CABLE ROLLERS, CUT-OUTS
11KV 33KV CABLE JOINTS & CABLE TERMINATIONS
FURSE EARTHING
www.cablejoints.co.uk
Thorne and Derrick UK
Tel 0044 191 490 1547 Fax 0044 191 477 5371
Tel 0044 117 977 4647 Fax 0044 117 9775582
