uTrust 5501 F – User Manual
Version: 1.3
Page 5 of 5
Follow the sequence of steps to communicate with the contactless card,
Plug in the reader to a Windows PC and load the driver
Launch the PCSCDIAG utility
Place a contactless card on top of the reader
Check the ATR of the card being displayed in the PCSCDIAG Utility.
To test the module after integration into device, follow the procedure from device
manufacturer.
6
FCC Statements
FCC
P
ART
15.105
S
TATEMENT
:
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC
P
ART
15.19
S
TATEMENT
:
This device complies with part 15 of the FCC rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
FCC
P
ART
15.21
S
TATEMENT
:
NOTE: The grantee is not responsible for any changes or modifications
not expressly approved by the party responsible for compliance. Such modifications could void the
user’s authority to operate the equipment.
7
ISED Statement
The device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science
and Economic Development Canada’s license-exempt RSS(s).Operation is subject to the following
two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR
d'Innovation, Sciences et Développement économique Canada applicables aux appareilsradio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) L' appareil ne doit pas produire de brouillage;
(2) L' appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
estsusceptible d'en compromettre le fonctionnement.
