uTrust 5501 F – User Manual
Version: 1.3
Page 4 of 5
1
Scope of the document
The user manual specifies the basic application of the reader by the customer.
2
Identiv uTrust 5501 F reader family
Identiv uTrust 5501 F is a family of USB based contactless card reader. The readers connect
to a host PC via USB 2.0 Full speed interface. They support ISO14443 and ISO15693 cards
in HF mode and 125 KHz LF cards. The information in this manual applies to the devices
model numbers listed below along with their respective part number, FCC ID and ISED ID:
Part Number
Product Name
FCC ID
ISED ID
905567
uTrust 5501 F HF + LF
MBPUT5501F-01
7485A-5501F01
905567-2
uTrust 5501 F HF + LF DTC MBPUT5501F-01
7485A-5501F01
905567-3
uTrust 5501 F HF
MBPUT5501F-01HF
7485A-5501F01HF
3
Driver Installation in Windows
Follow the sequence of steps to install the driver
Plug in the reader to a Windows PC
The PC prompts for a driver
Select Microsoft CCID driver and install the driver
The device enumerates with Identiv VID and PID strings
4
Host Communication Interface
Host communication is through the 1x5 header marked USB host.
Pinouts for USB host connector is as below:
PIN # Signal
1
Vbus
2
D-
3
D+
4
GND
5
Shield
The mating connector/receptacle for the header is TE Connectivity 440129-5
5
Communication with Card
Follow the procedure described below if module is tested in standalone mode when it is not
integrated into any device.
Follow the sequence of steps to communicate with the SAM card,
Plug in the reader to a Windows PC and load the driver
Launch the PCSCDIAG Utility
Insert the contact card into the card slot of the reader
Check the ATR of the card being displayed in the PCSCDIAG Utility
