IDEETRON Nexus LoRaWAN, Руководство пользователя

Страница: 10 / 20

Pagina 10 of 20 14-4-2017
Nexus LoRaWAN
7.11 mac set/get cnf
With this command you can set the message type of the LoRaWAN message. It can be set to a
confirmed or unconfirmed message. This determines if you request an acknowledge from the
LoRaWAN service.
To read confirmation sent: mac get cnf
To write confirmation sent: mac set cnf [Confirm]
[Confirm] can have the following values:
00 Unconfirmed message type
01 Confirmed message type
The answer form the nexus is:
Confirm: [Confirm]
7.12 mac set/get chop
With this command you can chose if channel hopping is activated. When channel hopping is
activated every data message will be send on the next channel. If the last message was sent on
channel 07 it will go back to channel 00. See Table 8 for the different channels
To read channel hopping sent: mac get chhop
To write channel hopping sent: mac set chhop [Channel hopping]
[Channel hopping] can have the following values:
00 No channel hopping
01 Channel hopping active
The answer form the nexus is:
Channel Hopping: [Channel hopping]
7.13 mac set/get class
With this command you can set the device class for the Nexus. This sketch supports type A and C.
A type A device will be inactive until you sent a message. After sending a message the type A
device will switch on the receiver in the listen for a possible message in receive slot 2.
In a type C device the receiver is always switched on, and can receive a message any time.
To read the class sent: mac get class
To write the class sent: mac set class [Class]
[Class] can have the following values:
00 Class A
01 Class C
The answer form the nexus is:
Mote Class: A/C