IDEC WB1F Series, Руководство пользователя

Страница: 62 / 116

2. Installation & wiring Function 4. Support tool 5. Appendix 1. Overview
3-39
Configuration item table
Item Sub item
Address
(hex)
Size
(dec)
Default
(hex)
Setting value
(hex)
Remarks
CCD setting
CCD drive setting 0170 1 00
00: Standard
01: Always
Standard: Driven each time
reading occurs.
Always: Driven regularly after
startup.
Number of CCD
Idling times
0171 1 05 01-0A: (0 to 10 times)
Specify the number of pre-
liminary operations to be run
until the CCD drive is stabilized.
Entering a larger value will
increase stability but will de-
crease the read speed.
When “CCD drive setting” is set
to “Always”, set this setting to “0”.
Reserved 0172-01FF 142 - -
Barcode reading
Reading operation
selection
0200 1 00
00: Single label read
01: Multiple label read
sequential output
02: Multiple label read
collectively output
Reading timeout time 0201 1 14
00: Infinity
01-FF: Setting value by 100ms step
(100 ms to 25,500 ms)
Set the maximum time to contin-
ue the reading operation from the
occurrence of a reading request.
Set the setting value to infinity in
the usage that the reading oper-
ation synchronizes with the ex-
ternal trigger input or the start/
stop barcode reading command.
Prevention time of
same read
0202 1 14
00: None
01-FF: Setting value by 100ms step
(100 ms to 25,500 ms)
Sets the time that the same bar-
code will not be read when per-
forming multiple label reading.
Verification count 0203 1 01 0-10: Verification count
Sets the number of times to
check that there are no mistakes
in the readout data.
Increasing the verification count
can reduce erroneous reads, but
the response speed will also de-
crease.
Reading start
when power on
0204 1 00
00: Disabled
01: Enabled
When the setting value is en-
abled, and the WB1F is power up,
the WB1F starts reading barcode.
Reading operation selection,
reading timeout time, prevention
time of same read, and verifi-
cation count follow the setting
value.
Reserved 0205-027F 123 - -