14
TP10KAC-DX
July 2018
5. Install Hydraulic Cylinders
A. Install the cylinder to the cylinder mounts (uprights) with
9/16” x 4-1/2”
pins, cylinder bushings
(spacer) washers, and snap rings, as in figure 5a
. The hose connecting port near the other end
of the cylinder should be positioned pointing to the column
’s opening. (Fig. 5b)
B. Bolt the cylinder rods to the carriages. (Fig. 5c
）
NOTE: MAKE SURE SNAP RING ON CYLINDER
ROD IS IN
SECURED IN
GROOVE
.
Fig. 5a
Fig. 5b Fig. 5c
DO NOT HOLD THE CYLINDER ROD IN A WAY THAT COULD DAMAGE THE FINISH. CYLINDER
LEAKS CAUSED BY DAMAGED RODS ARE NOT COVERD UNDER WARRANTY.
6. Columns Positioning & Main Side Column Anchoring
A.
Carefully stand up the Main side column (w/ power unit bracket) & Off side column
, position
the columns where they are to be secured. Ensure column
’s openings are facing each other.
THE MAIN SIDE COLUMN MUST BE POSITIONED TO BE ON THE PASSENGER SIDE OR RIGHT
SIDE WITH THE VEHICLE HEADED FORWARD. THE DISTANCE BETWEEN COLUMN’S BACK
EDGE TO WALL, SHOULD BE AT LEAST 2 FEET FOR SAFETY.
B. Using the column base as a template, drill the anchor bolt holes for the
Main side column only!
(Refer to FOUNDATION REQUIREMENTS & ANCHORING TIPS ON PAGES 12 & 13)
NOTE: DO NOT ANCHOR OFF SIDE COLUMN AT THIS TIME!
C. Install the anchor bolts, assemble washers & nuts onto the anchor bolts. Thread the nuts onto the
anchor bolts where the tops of the nuts are just above the top of the anchor bolts. Carefully tap the
anchor bolts into the concrete until the washer rests against the base plate.
Ensure not to damage
threads
.
D. Using a level, plumb the Main side column both side to side and front to back. Shim the leg as
necessary using the Shims provided. Tighten anchor bolts to 110 ft. lbs. as noted on page 9. Re-
check to ensure column is plumb.
NOTE: REFER TO ‘FOUNDATION & ANCHOR REQUIREMENTS’ IF MORE THAN 1/2” OF
SHIMS ARE REQUIRED.
E. Ensure Off side column is in the correct location.
DO NOT DRILL HOLES FOR ANCHORS at this
time
.
