IDEAL IMAX XTRA E80, Руководство пользователя

Страница: 5 / 8

IMAX XTRA -
Users
To shut Down the Boiler
1. For short periods
Set the external controls to OFF. Wait 10 minutes and then
isolate the mains supply to the boiler.
2. For longer periods
Set the external controls to OFF. Wait 10 minutes and then
isolate the mains supply to the boiler. For longer periods the
entire system should be drained, including the domestic hot
water supply.
To Relight the Boiler
Refill the system if it has been drained, taking care to ensure no
air is in the boiler or system.
Repeat the procedure detailed in 'To light the boiler'.
Frost Protection
The IMAX XTRA b oiler has built into its control system the
facility to protect the boiler only against freezing.
Note
.
This may not protect remote parts of the system, in which case
a separate frost thermostat should be fitted.
Boiler Overheat
Boiler overheating is detected by electrical sensors connected
to the boiler control module. If the boiler overheats it will shut
down and the display will show E18. Press the 'reset' button (D)
and the boiler will relight. If the fault recurs turn off the boiler
and consult a CORGI registered installer or in IE a competent
person.
Condensate Drain
The condensate drain must not be modified or blocked.
Blockage of the condensate drain, caused by debris or freezing,
can cause automatic shutdown of the boiler or leakage from the
condensate trap mounted on the bottom of the boiler.
If freezing is suspected and the pipe run is accessible an attempt
may be made to free the obstruction by pouring hot water over the
exposed pipe and clearing any blockage from the end of the pipe.
If this fails to remedy the problem the assistance of a CORGI
registered installer or in IE a competent person should be sought.
Escape of Gas
Should a gas leak or fault be suspected contact your local gas
supplier without delay.
Do NOT search for gas leaks with a naked flame.
Cleaning
For normal cleaning simply dust with a dry cloth.
To remove stubborn marks and stains use a damp cloth and mild
detergent.
DO NOT use abrasive cleaning materials.
5