IDEAL EC1, Установка и обслуживание

Страница: 46 / 68

46
insTallaTion
Solar Thermal -
Installation and Servicing
SOLAR CONTROLLER
41 iDeal solar conTroller - safeTy insTrucTions
1. Please see that fire safety cable systems and similar systems
are not impaired.
2. The controller must not be installed and used in damp
areas (e.g. bathrooms) or in rooms in which flammable gas
mixtures (by gas bottles, paint solvents etc.) are likely to
occur.
3. Do not store any of the above or similar items in a room
where the solar controller is installed.
4. The controller must not be installed on a conductive base.
5. All operations must be conducted in accordance with the
national electrical regulations and local rules.
6. For your own safety please note the following for electrical
installation:
The controller has been built for the use at 230 V (±15 %) AC
at a frequency of 50 Hz. Using this controller for other voltage
values is not allowed. Please also note that the admissible
nominal currents must not be exceeded. If there is a
grounded conductor planned or laid down for pump or
reversing valve it MUST also be connected. There are
corresponding supply terminals. Please make sure that
the earthing contact is led to the controller also on the
power supply side.
7. Wires that are not permanently connected with the
building have to be equipped with a strain relief clamp
outside the controller. The controller is only for the
prescribed applications. No liability is taken over for
other utilization. All operations on an open controller
are only to be conducted cleared from the power
supply. All safety regulations for working on the power
supply are valid. Connecting and/or all operations that
require opening the controller (e.g. changing the fuse)
are only to be conducted by a Solar competent heating
engineer. The controller is protected against overload
and short circuit.
installation site
The controller is designed for assembly on vertical walls. Installation of the controller is only permitted in an area that provides
appropriate protection (see technical data). The ambient temperature at the installation site may never fall short of or exceed the
maximum ambient temperature allowed.
42 iDeal solar conTroller - mounTing
Wall mounting
1.
The internal controller cover protects the controller’s
electronics and may not be removed for installation purposes.
2. Drill and plug the wall in the desired position. Affix the central
screw and place the controller in position.
3. The controller can be used as a template to mark both
additional mounting holes.
noTe. Only use the controller as a marking template, never as a
drilling template.
2
3
3
1
sol8572
116.5mm
Fuse
105mm 124mm
129.5mm
207786-2.indd 46 16/02/2012 11:26:24