IDEAL DN50, Руководство по установке

Страница: 3 / 16

3
EVOMAX - Low Height Frame & Header Kits
1 INTRODUCTION
These low height rig kits have been designed to
enable them to be fitted in a standard height room
leaving ample space for flue installations and are
supplied with gas and water header kits designed
for use with a low loss header system.
They are based around a single frame structure with
provision to bolt multiple frames side by side up to
3 wide, along with all the necessary mounting holes
to enable the fitting of the header kits and frame
securing bolts.
This manual contains all the technical and
dimensional data required to install these kits.
GENERAL DESCRIPTION OF FRAME AND
HEADER KITS
These are a compact system with three single
frame configurations and integrated water and gas
headers, affording floor mounting capability to the
entire Evomax range of products. These systems
are adapted to incorporate the use of low loss
headers and optional sequencer control systems.
All these kits are supplied with the relevant
number of energy efficient pumps and necessary
parts needed to connect these kits to the
separately purchased Evomax appliances.
Check the kit contents with the list below.
UNPACKING
Kit Contents
Frame Water Header Hardware Pack
Connection
Hardware Pack
Misc
Pump
DN50 1 off 1 off 1 off n/a 1 off
DN65 2 off 1 off 1 off 1 off 2 off
DN80 3 off 1 off 1 off 1 off 3 off
The flue configurations for the Evomax range of appliances using these system kits are C13, C33 & B23 (See appliance
manual). Note . In the case of the 150kW boiler, this must be flued in accordance to the clean air act.
All headers and pipe work should be insulated in accordance with the Non Domestic Building Services Compliance
Guide. To ensure compliance with the maximum heat loss criteria, insulation thickness should be calculated according to
BS EN ISO 12241 using standardised assumptions