- 88 -
AW 60
Power cord is plugged in.
Low Water Indicator light
is on.
Water is filled inside water
tank.
Plug the power cord in.
Fill the water tank.
Make sure the water tank is
in place and filled correctly.
HumidiPür
TM
does
not turn on
Power cord is plugged in.
Auto Mode Indicator is on.
Unplug power cord and
plug it back in.
Push FUNCTION button to
select Auto Mode.
Auto Mode is not
working
The unit is located on an
uneven surface.
Move to an even surface.
Vibrates or makes
noise
Power cord is plugged in.
Power cord is hot
Unplug the power cord and
contact customer support.
TROUBLESHOOTING
When evaluating the
performance of the Humidipür,
keep in mind that there are
various factors that influence
humidity level such as:
•
Home insulation
•
Layout
•
Air circulation
•
Water level of the CleanCel
water tank
•
Ceiling height and square
footage
If the unit is utilizing the water
inside the CleanCel water tank
more than once daily, then the
unit is operating properly. Refill
water regularly for optimal
performance.
Note :
In the case of extremely
dry environments, continuous
operation of the Humidipür unit
(up to 1 week) is recommended.
Humidity level reading is
not changing or does
not reach desired level.
Child-Lock mode is on.
Push Plasma/Child Lock
button for 3 seconds to
turn OFF Child-Lock mode.
Function button is
not working
HumidiPür
TM
is being used
where strong odors and/or
dust is present
Replace the water in the
water tank and change water
more frequently.
Clean water tank and
CleanCel Antibacterial
Discs.
Unpleasant odors are
present
Water is left inside the
water tank.
Low water level indicator
is on despite water being
in tank
Refill the water tank.
Symptom
Check If:
Solution
Dépannage
AW 60 ne se met pas
en marche
Le mode Auto ne
fonctionne pas
L’appareil vibre ou fait
du bruit
Le cordon d’alimenta-
tion est chaud
-
le cordon d’alimentation
est branché
- le voyant de faible
niveau d’eau est éclairé
- le réservoir d’eau est
plein
-
le cordon d’alimentation
est branché
- le voyant de mode Auto
est éclairé
-
l’appareil est posé sur
une surface irrégulière
-
le cordon d’alimentation
est branché
-
branchez le cordon
d’alimentation
- remplissez le réservoir
d’eau
- assurez-vous que le
réservoir d’eau est bien
en place et rempli
correctement.
-
débranchez le cordon
d’alimentation et
rebranchez-le
- appuyez sur la touche
FONCTION pour
sélectionner le mode
Auto
-
déplacez-le sur une
surface régulière
-
débranchez le cordon
d’alimentation et
contactez le service
client
Symptôme
Vérifiez si :
Solution :