1S6416 Rev. 1 ECN 2021-0124
Page 4 of 5
PCB Mounting:
When mounting to a PCB, the standoffs on the bottom of the connector should be seated directly on the
board. The standoffs will allow a .020 (.51) gap between the bottom flange of the connector and the board.
This gap is essential for proper soldering. It is also advisable that hold downs are used for stability during
the soldering process. The PCB hole layouts for each connector are shown below.
035 Power Drawer
#12 and #20 AWG
075 Power Drawer
#8, #12, and #20
Connector Engagement:
Drawer connectors are fully mated when the gap between the pin and socket housings is equal to .50
(12.7) for the middle drawer connector and .40 (10.2) for the lower drawer connector, as shown in the
diagram below. The connectors must be allowed to mate to this distance to ensure full engagement of
the pin and socket contacts.
Содержание APP Power Drawer
Страница 5: ...1S6416 Rev 1 ECN 2021 0124 Page 5 of 5...
