IDEAL Networks VDV II PRO, Руководство пользователя

Страница: 7 / 62

158802.02 VDV II Pro 4
En
Backlight
Indicator
Setting
Indicator
VOICE port
selected
VIDEO port
selected
DATA port
selected
Battery
Low
Indicator
POWER
To remove / insert the battery:
• Remove the battery cover screw and the
battery cover from the back of the tester.
• Remove / insert the battery, taking care to
connect correctly and not to trap the cable.
•
Replace the battery cover and screw.
To switch the tester ON:
•
Press the ON/OFF button.
o The display shows the selected port
(VOICE, VIDEO or DATA).
o If the Battery Low Indicator is shown,
the battery should be replaced with a
new 9V battery.
To control the backlight:
• Press the TOOLS button repeatedly until the Backlight Indicator flashes and the backlight
timeout (seconds) is shown.
• Press

or

to adjust the backlight timeout.
o
If zero, the display shows

. The backlight will not come on.
o If non-zero, the display shows

. The backlight will come on whenever any button is
pressed and after the timeout will first be dimmed and then go off to maximise
battery life.
• Press the TOOLS button repeatedly until the Setting Indicator disappears.
To switch the tester OFF:
•
Press the ON/OFF button.
TERMINATIONS
The Dual Port Remote Unit can be stored in the bottom end of the Tester, with the jacks
either inside for protection or outside for testing patch cables without removing it from the
Tester, and provides internal storage for the Coax Remote Unit.
Termination
Number
Identifier
Indicator
Remote
Unit
Indicator
CONNECTIONS
To connect to a cable and to confirm correct connection:
• Use the correct port (VOICE, VIDEO or DATA) according to the
cable connector type. (Use VOICE for RJ11, RJ12, RJ14 or RJ25
cables, VIDEO for
F 75
Ω
Coax or DATA for RJ45).
• Press the corresponding port button (VOICE, VIDEO or DATA).
o
The display shows the selected port.
• Connect one end of the cable to the selected port on the tester
and the other end to a Remote Unit for cable identification and
testing or to an Identifier for cable identification only.
o
The display shows the type of termination (Remote Unit
or Identifier) and its Number to assist identification when
a number of different terminations are in use.
Dual Port Remote Unit
# 1 (Standard)
Coax Remote Unit
# 1 (Standard)
# 1 to 12 (Optional -
158053)
RJ45 Remote Unit
# 1 to 12 (Optional -
158050)
RJ45 Identifier
# 1 to 24 (Optional -
158051)
Battery cover
screw
Battery cover