5
IMPORTANT NOTES
•
This appliance must not be operated without the casing correctly fitted and forming an adequate seal.
•
If the boiler is installed in a compartment then the compartment MUST NOT be used for storage purposes.
•
If it is known or suspected that a fault exists on the boiler then it MUST NOT BE USED until the fault has been corrected by
a Gas Safe Registered Engineer or in IE a Registered Gas Installer (RGII).
•
Under NO circumstances should any of the sealed components on this appliance be used incorrectly or tampered with.
•
This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given supervision or instructions concerning use of the appliance
by a person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
In cases of repeated or continuous shutdown a Gas Safe Registered Engineer or in IE a Registered Gas Installer (RGII) should
be called to investigate and rectify the condition causing this and carry out an operational test. Only the manufacturer’s original
parts should be used for replacement.
MINIMUM CLEARANCES
Clearances of
165mm
above,
100mm
below,
2.5mm
at the sides. The minimum front clearance when built in to a cupboard is
5mm
from the cupboard door but
450mm
overall clearance is still required, with the cupboard door open, to allow for servicing.
Bottom clearance
Bottom clearance after installation can be reduced to 5mm.
This must be obtained with an easily removable panel to provide the 100mm clearance required for servicing.
