Ideal Boilers FF 350, Установка и обслуживание

Страница: 26 / 40

26
Classic FF -
Propane Installation & Servicing
INSTALLATION
Knob Setting Flow Temperature
°C °F
1 54 130
2 60 140
3 66 150
4 71 160
5 77 170
6 82 180
emphasise that if cutout persists, the boiler should be
turned off and a CORGI registered installer consulted. In
IE contact a Competent Person.
7. Explain and demonstrate the function of time and
temperature controls, radiator valves etc., for the economic
use of the system.
8. If any programmer is fitted, then draw attention to the
Programmer User's Instructions and hand them to the
Householder.
9. After installation, commissioning and customer hand-
over, please complete the appliance log
book and leave this with the customer. For IE, it is
necessary to complete a "Declaration of Conformity" to
indicate compliance to I.S. 813:2002.
10. Stress the importance of regular servicing by a CORGI
registered installer and that a comprehensive service
should be carried out AT LEAST ONCE A YEAR. In IE
servicing work must be carried out by a Competent Person.
1. Hand the User's Instructions to the Householder and explain
his or her responsibilities under the current Gas Safety
(Installation and Use) or rules in force.
2. Draw attention to the Lighting Instruction label affixed to the
controls pod door.
3. Explain and demonstrate the lighting and shutting down
procedures.
4. The operation of the boiler and the use and adjustment of
ALL system controls should be fully explained to the
Householder, to ensure the greatest possible fuel
economy, consistent with household requirements of
both heating and hot water consumption.
Advise the User of the precautions necessary to prevent
damage to the system and to the building, in the event of
the system remaining inoperative during frosty conditions.
5. Explain the function and the use of the boiler thermostat and
external controls.
6. Explain the function of the boiler overheat thermostat and
After completing the installation and commissioning of the system the
installer should hand over to the householder by the following actions:
48 HANDING OVER
c. Refill and vent the system, clear all air locks and again
check for water soundness.
d. Balance the system.
5. Finally set the controls to the user's requirements.
The temperatures quoted below are approximate and vary
between installations:
46 INITIAL LIGHTING - continued
WARNING. The boiler MUST NOT be
operated with the casing removed.
47 GENERAL CHECKS
Make the following checks for correct operation:
1. Set the boiler thermostat knob to position 6 and operate the
Mains on/off switch. Check that the main burner lights and
extinguishes in response.
2. The correct operation of ANY programmer and all other
system controls should be proved. Operate each control
separately and check that the main burner or circulating
pump, as the case may be, responds.
3. Check that the casing is sealed correctly and compressing
the sealing strip all around the casing.
4. Water Circulating System
a. With the system HOT, examine all water connections for
soundness.
b. With the system still hot, turn off the gas, water and
electricity supplies to the boiler and drain down in order
to complete the flushing process.
15. Swing the control box back into
its working position and secure.
16. Remove the boiler casing.
17. Refit the controls pod to the
boiler casing and tighten the 2
front fixing screws.
18. Refit the complete casing to the
boiler.
19. Close the pod door.
INST
ALLA
TION