Ideal Air Portable Air Conditioner, Руководство пользователя

Страница: 6 / 9

8 9
Installation
Installation
Vertical
Window
Shown with
optional
Window
Slider Kit
and Duct
Adapters
installed.
A
Fig. 2
Fig. 3
Fig. 4
Window Slider Kit Installation
Installing the Window Slider Kit in a Vertical, Double-Hung Sash Window
Locking Bolt
Adhesive
Foam Seal
Adhesive
Foam Seals
Adhesive
Foam Seal
Window
Slider Kit
Adhesive Foam Seal
Slider
A
TYPE I
TYPE II 2.22 to 4.04 ft. (67.5 – 123 cm)
1.84 to 3.22 ft. (56.2 – 98.2 cm)
The air conditioner should be placed on a firm
surface to minimize noise and vibration. For safe
and secure operation, place the unit on a smooth,
level floor strong enough to support it.
The unit has casters to aid in moving but it should
only be rolled across smooth, flat surfaces. Use
caution when rolling on carpeted surfaces. Do not
attempt to roll the unit over objects.
The unit must be placed within reach of a properly
rated and grounded socket.
Allow at least 12” (30cm) of space from the wall for
efficient air conditioning. (Fig. 1)
12” (30cm)
12” (30cm)
Fig. 1
Fig. 5
Fig. 6
Fig. 7
Fig. 8
Your optional, 2-piece Window Slider Kit has been
designed to fit most standard vertical and horizontal
windows (Fig. 2 & 3). However, it may be necessary
to cut the Slider shorter to fit windows that are less
than 2.22 ft. (67.5 cm) wide (Type I) or less than 1.84
ft. (56.2 cm) wide (Type II). See Fig. 4 below for
minimum and maximum window openings (A) that the
Window Slider Kit will fit without modification.
1. Cut 1 piece of Adhesive Foam Seal to the proper
length, raise the window sash and attach the foam
to the window stool (Fig. 5)
2. Adjust the length of the Window Slider Kit to the
width of the window. Shorten the Slider if the width
of the window is less than 26.5” (Type I) or 22.1”
(Type II). Place the Window Slider kit on top of the
Adhesive Foam Seal (Fig. 6)
3. Cut another piece of Adhesive Foam Seal to the
proper length and attach it to the top of the Window
Slider Kit. Close the window sash securely against
the Top of the Window Slider Kit (Fig. 7).
4. Cut a third piece of Adhesive Foam Seal to the
appropriate length to seal any gap between the
top window sash and outer window sash (Fig. 8).
Air Conditioner Placement
Horizontal
Window
A