UM_T
EO
d8_v1_D
EF
10
3.Setup And Operation
Before plugging the processor in, always make sure that the power supply matches the product specification voltage. Install
this device on a flat, stable surface. Do not supply power before all components of the system are set up and connected
properly. Make sure to power-up your device before your power amplifiers are switched on in order to avoid transients, which
could damage you.
3.1.System Check
After connecting all cables, you should mute all outputs first or turn the gain/level setting on your amplifiers to minimum.
Activate the HF-outputs first. In case of wrong cabling, High Frequency (HF) audio signals will come out of bass-speakers that
cannot be harmed this way. Vice versa, the Low Frequency (LF) audio signals would destroy your HF-speakers.
3.2.Input Setup
Press the Channel Up or Down button to select the input channel you wish to edit. Make the first settings with the output
turned low or muted. To toggle through the different menus, press the Item Up or Item Down buttons.
3.2.1.Gain
Adjust the gain by dialing the rotary encoder. The gain is adjusted in steps of 0.25dB. Smaller steps (0.01dB) can be set via the
PC or MAC IDEA DSPControl software.
In AB Gain
-2.25dB
3.2.2.Input Selection
Select the source (Analog or AES/EBU) by rotating the encoder.
3.2.3.Delay
Set the delay time by turning the encoder. Select the displayed unit (ms or s, mm or m, feet, inches, or mils) by pushing the
encoder.
In AB Input
Analog
In AB Input
AES/EBU
In AB Delay
1.02ms
In AB Delay
100.23m
In AB Delay
244.5Feet