Ide Line ide line 770-056, Руководство пользователя

Страница: 10 / 17

10 10
INTRODUCTION
Please read all instructions before operation your
new boot and shoe dryer. We suggest that you
save the instruction manual for later use.
(230 V ~50 Hz)
Safety instructions:
1. Connect the appliance only to 230V a.c.
2. Do not cover the appliance with laundry or
anything else.
3. Exit of warm air must not be blocked.
4. During the heating operation the cord should
not come in touch with the appliance.
5. Caution: do not use the appliance in the
immediate vicinity of bath tubs, showers, wash
basins or swimming-pools.
6. Never immerse the appliance into water and
other liquids. If it has been in any contact with
water - unplug immediately.
7. After use and before cleaning always switch off
the appliance and unplug.
8. Often children do not recognize the dangers of
handling an electrical appliance. Do not permit
them to use it without proper supervision.
9. Do not touch the appliance during the heating
operation - it gets hot.
10. Do not use the heater if the appliance or the
cord has been damaged. Hand it over to an
authorized specialist for repair.
11. The heater is for indoor use only.
12. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening, as this may
cause an electric shock or fire, or damage the
heater.
13. Be sure that no other appliances are plugged
into the same circuit with your heater, as circuit
overload could occur.
OVERVIEW:
1. Grid
2. Timer
3. Control lamp
4. Hose
5. Wall mounting bracket
WALLMOUNTING:
• Fasten the wall mountiong bracket on a wall so
the hoses reaches the floor.
Note: Place the mounting bracket with the arrow
with “Top” indication pointing up.
• Place the shoe and boot dryer over the bracket
by clicking it in place.
OPERATION:
1. Plug in the appliance.
2. Place the hoses in the boots or shoes that
needs to be dried.
3. Turn the timer to the desired time – the dryer
will start and the control lamp will light.
4. The control lamp will be on as long as the dryer
is activated
5. When the timer is back to “0” the dryer will
stop. If the futher drying is needed, just turn the
timer again.
Overheating protection:
In case of heat accumulation a protective device
against overheating will switch off the heating
automatically.
• If the overheating protection has switched off,
please proceed as follows:
• Switch off the appliance (pull out the plug)
• Remove the overheating cause (e.g. covered
air-intake grid inhibition of air circulation, dust,
fluff etc.).
• Let the appliance cool down for a few minutes.
• Then the appliance can be switched on again.
UK
1.
2.
3.
4.
5.