Manual IB-3740-C31
- Connect the power adapter and connect the USB Type-C
™
cable to your computer and power on the device.
When connected and powered on, the power LED will turn blue; the HDD LED lights will turn blue.
If there are drives installed, the HDD LED will stay blue. If the HDDs are accessed the corresponding HDD LED will flash
blue.
- Complete the drive settings inside the
Disk management
of your computer system.
General information
• When the USB cable is plugged out, the device goes to sleeping mode automatically (if sync. mode is activated).
• To take out the drive or carrier from the device, slightly press down the handle of the tray and pull it out.
• Setting up motherboard‘s power management in S3 is recommended.
• (For more details refer to the user guide of motherboard BIOS setting).
• If the device takes too long to initialize, please check if the drive is securely installed.
• If there is noise with the fan, power off the device, unscrew the fan, take out the cover,
• clean the fan end assemble it back.
• If the noise is still present, you can change the fan with another identical fan of Size
• 80x80x20 mm.
• If the fan stops working, do not dismantle it. Please send back to the retail store immediately.
• Smart fan controlled by the built-in thermal sensor and it comes with two modes (auto/manual) and three levels of
speed:
Level 1 below 45° C = 1,000 rpm ~ 1,400 rpm
Level 2 45° C - 54° C 1,500 rpm = 1,900 rpm
Level 3 higher than 55° C = 2,400 rpm ~ 2,800 rpm
• The IB-3740-C31 is also working with computer/notebook with Type-C
™
USB 3.0/2.0 and Thunderbolt
™
3
interfaces. The full transfer rate up to 10 Gbit/s can only be reached, if the USB 3.1 (Gen 2) protocol will be
supported.
