OVERHEAD ARM INSTALLATION 01/20/16 pjm
Page 4 of 4
overhead arm installation
AfTEr MOUNTINg ArM TO wALL PLATE,
fOLLOw INsTrUCTIONs TO MOUNT MONITOr
AND MANAgE CAbLEs.
moUnt overhead arm
attaCh Cover Plate
Slide overhead arm
into wall plate clamps.
Snap cover plate onto
wall plate.
Attach using 10-
24x3/8” Phillips head
machine screws.
Wall
plate
clamps
Firmly tighten clamp
screws on left side of
clamp with 3/16” hex
key. To adjust rotation
tension of arm, tighten
or loosen tension
screws on right side
of clamps.
Tension
screw
Clamp
screw
The plastic straps and cap washer are positioning and
retention elements only. They do not otherwise function as
anchoring elements. Holding is dependent only on a metal
bolt to metal channel connection. The SnapToggle anchor
complies with all existing fire codes for critical applications.
Handle
Cap
straps
Anchoring
Channel
Drill 1/2” hole. Hold metal
channel flat alongside
plastic straps and slide
channel through the hole.
Minimum clearance behind
wall is 1-7/8”
Hold ends of straps together
between thumb and fore-
finger and pull toward you
until channel rests behind
wall. Ratchet cap along straps
with other hand until flange of
cap is flush with wall.
Place thumb between straps
at wall. Push thumb side
to side, snapping off straps
level with flange of cap.
Snap Toggle Instructions
