Page 1
overhead arm installation
OVERHEAD ARM INSTALLATION 01/20/16 pjm
Page 1 of 4
MAXIMUM LOAD CAPACITY:
28 Lbs (12.7 kg)
attaCh traCK adaPters
Attach 4 track adapters
to back of wall plate
by threading socket
head screws from
front of wall plate
into track adapters.
Loosely tighten
with 3/16” hex key.
Insert screws
from front
attaCh Wall Plate to traCK
Slide track adapters
into track from
either top or bottom.
Position wall plate to
desired location on
track. Firmly tighten
wall plate screws
with 3/16” hex key.
attaCh vesa to monitor
Track
adapters
Wall
plate
Attach VESA to monitor using
the four 4mm screws provided.
moUnt overhead arm
Slide overhead arm into
wall plate clamps. Firmly
tighten clamp screws on
left side with 3/16” hex key.
To adjust rotation tension
of arm, tighten or loosen
screws on right side of
clamps.
Clamp
screws
Tension
screws
Wall plate
clamps
moUnt Wall traCK to Wall
Using a Phillips
drive, remove
plastic cap on
one end of track.
Save this cap to
put back on when
track installation
is complete.
Locate the wall stud and mark the top center hole of
the Wall Track. Drill a 11/64 pilot hole, insert a #14
screw and tighten slightly. Using a level, mark the 9
lower holes in the center of the track, drill pilot holes
and then insert the #14 screws. Use all 10 screws.
NOTE:
#14 Wood screws are supplied with unit. If
installing into
metal studs
, you will need to replace
these with proper metal stud fasteners. All hardware
used to secure track mount must have a proper
countersunk head.
Ul182-ohat
Wall track mount
Ul182 ohaP
Wall Plate mount
Wall Plate instructions on p.3
