If you have any questions please call Toll Free 1-800-558-4435
Page 2 of 4
T2P2020 INSTALLATION 9/8/15 pjm
t2P2020 installation
iF UsinG Wall MoUnt
iF UsinG PolE MoUnt
iF UsinG DEsK MoUnt
attaCH Wall PlatE to Wall
Locate stud and mark top
hole, drill 11/64 pilot hole
and insert #14 screw and
tighten slightly. Using a
level, mark lower hole and
drill pilot hole, insert #14
screw and, with unit level,
tighten both screws. Insert
and tighten middle screw.
ICW supplies #14 wood
screws. If installing onto
metal studs, you will need
to replace with proper
metal stud fasteners.
attaCH PolE MoUnt to PolE
Detach the pole mount from arm using
the provided 5mm hex key. Separate
the two sections of the pole mount using
the provided 5/32 hex key. Place around
the pole you are mounting to and firmly
reassemble the pole mount.
Mount Arm to Wall, Pole or Desk
attaCH DEsK MoUnt to DEsK
Cords lay in groove
Detach desk mount
from arm. Feed cords
through the arm,
bearing and rotation
limiter, then through
the groove in the desk
mount.
Re-attach desk mount
to arm by screwing
button head bolt into
center hole of mount
from underneath.
Screw 3/8 All Thread
bolt into offset hole in
base of desk mount.
The bolt is included in
the hardware bag.
Drill a 3/8 hole through the horizontal
mounting surface. Push the All Thread
bolt on desk mount assembly through
the hole in the horizontal surface.
Slide large mounting washer over the
bolt from underneath and secure in
place with the 3/8 nylock nut.
Please follow cord management instructions before securing
desk mount to surface.
Use
offset hole
for All Thread
bolt
Mounting surface
Nylock nut
Mounting surface
Washer
Replace bolt in mount
