
6
5. Insert the power supply cable through the opening in the screw
connection.
6. Pull the power supply cable into the housing approximately 150 mm.
The power supply cable must be long enough to be pulled into the
housing from the ground or wall.
7. Fix the power supply cable in the screw connection by tightening it in
such a way that there is no movement in the power supply cable.
8. Remove the sleeve of the power supply cable using wire stripping
pliers so that the cores are sufficiently exposed to be able to be
installed in the isolator switch.
9. Fix the cores at the correct location in the earth-leakage circuit
breaker. Always install the earthing first! See figure 3.1 (1-phase
variant) or figure 3.2 (3-phase variant).
Figure 3.1: 1-phase variant)
Figure 3.2: 3-phase variant)
10. Switch on the isolator switch after the power supply cable is live.
11. Connect the wiring of the LEDs back on the connector that was
disconnected in step 1.