5 times, this function will be turn off automatically.
6
、
For re-active this function, please follow step 2.
Attention:
1
、
The system still under arm status during the process of engine start.
2
、
If handbrake did not close well, siren will chirp once to indicate when you
press or on remote.
3
、
If the handbrake did not close well,siren will chirp for 3 long times to warm
owner that the vehicle can not be start normally, the system will back to its
original state.
4
、
When start the vehicle, it must be placed in neutral or P position. Autom-
atically start function will be turn off after disarm the system.
8.22
、
Timing automatically start------This function can be selected by
programming function:
1
、
Set this function is turned ON
2
、
After press or on remote, the system enter into arm status, then
press for 2 seconds, the engine will be start and 20 minutes later turn
off, indicating system has enter into timing automatically start function.
3
、
The vehicle will start automatically 20 minutes for every two hours,
and it continue 5 times, then the system will turn off this function.
4
、
For re-active this function, please repeat the step 2.
Attention:
1
、
The system still under arm status during the process of engine start.
2
、
When the handbrake is not effect well,siren will chirp for 3 long times
to warm owner that the vehicle is under abnormal condition and can not
be start normally.
3
、
When start the vehicle, it must be placed in neutral or P position. Timing
automatically start function will be turn off after disarm the system.
8.23
、
Low temperature detecting engine start and Timing engine start can
not be use at the same time. Once you choose 'L' mode then the 'T' mode
will be turn off automatically.
8.24
、
One button start function
（
please refer to Installation wiring
diagram
）
Operation method:
1
、
Press start button by following: open ACC~ON~OFF~ ACC......
2
、
Step on foot brake when the LED indicator of the push start button turn
to purple, and then press the start button for 2 seconds to STOP.
PKE Function description
With the Automation and the intelligence, and the most advanced RFID
function, can by detecting the transmitter of the owner, to activation related
functions. Remark: this function must be available by using transmitter
with PKE function and PKE function ON.
1. Automatically Lock and Unlock
：
In Arming status, when the user go near the car with the range that the
transmitter can be detected, the siren will sound two times, Direction light
will flash 2 times, the system will automatically unlock and disarm, (if it was
Mute arming status, then the siren will not make sound), the user can drive
the car, if the transmitter without in the detecting range, the system will
active and lock the door immediately, siren will sound one time, direction
light will flash once and arming.
2. RFID Automatically Identification
：
When the user start to drive the car and the key was turn to ON position,
the system will sending signal to transmitter within 5 seconds to identify,
after the identification complete, if fail to receive the signal once, the
system will lock the engine at once, but if detected the transmitter, then
can the drive the car normally, and system will stop the detecting the
transmitter.
3. Auto Anti-Hijacking
：
When user drive the car normally and detecting the doors open, the led
indicator will keep on to alert entered the Anti-hijacking status, the system
will identify the user after 1 minute, and the identification will last 1 minute,
during this 1 minute, if the PKE transmitter was detected, then can conti-
nue to drive the car, and during driving will not to detect the transmitter
any more, if can not be detected during this 1 minute, then will make alarm
at once, Siren will sound, the direction light will flash, and lock the engine
after 30 seconds, before and after the alarm stared, the system will always
to detecting the transmitter, once it was detected, the alarm will stop and
can drive the car again, so the user must keep the PKE transmitter with
you and avoid it be robed by the robber, during the auto Anti-hijacking, if
the transmitter was detected within the first 1 minute, the system will exit
the anti-hijacking at once, if the alarm is on, the system will have discon-
nection memory, which mean if cut off the power and then re-connected,
the system will still make alarm and lock the engine, by emergency release
and the press " " button on the transmitter or detected PKE transmitter can
(13)
(14)
